big base circle cam in stock elem.

[TILBURG]

Originally Posted by Bill Diehl

So what's the verdict here? Roller cam bearings? 60mm tunnel? offset lifters? Lifter dia?


lot of grey area to sort thru

Offset lifters? In a flat tappet BOY that will keep you busy.LOL

[Bill Diehl]

Originally Posted by TILBURG

Offset lifters? In a flat tappet BOY that will keep you busy.LOL

Bushings at the proper phasing angle. If you where building a record setting canted valve engine you would know that already.

Who says you can't offset the bushing fore or aft? And place the lobe where it needs to be. This is a high end tool steel cam and lifters

And for the guys that are going to jump all over me for moving the bushings to where they need to be......they been offset boring cylinder bores for years, what's the difference?

[TILBURG]

Originally Posted by Bill Diehl

Bushings at the proper phasing angle. If you where building a record setting canted valve engine you would know that already.

Who says you can't offset the bushing fore or aft? And place the lobe where it needs to be. This is a high end tool steel cam and lifters

And for the guys that are going to jump all over me for moving the bushings to where they need to be......they been offset boring cylinder bores for years, what's the difference?

Sorry Bill I thought I read offset lifter? Never worked on a record setting canted valve motor before but sounds like some neat stuff.

[Glenn Briglio]

Originally Posted by TILBURG

Sorry Bill I thought I read offset lifter? Never worked on a record setting canted valve motor before but sounds like some neat stuff.

Thanks Brian I just spit out my water on laptop! Never worked on a record setting canted valve engine. Lol

[FINESPLINE]

Originally Posted by Glenn Briglio

Thanks Brian I just spit out my water on laptop! Never worked on a record setting canted valve engine. Lol

Probably a few people cleaning up a mess by their computer ! lmao !!!!

[RJ Sledge]

Hey Badger......Just because they have a Policy Manual on hand doesn't mean they read it.......or its written in Latin. As per Dallas this year and the Don Davidson Teardown.

RJ

[Adger Smith]

OK, Sludge,
Point well taken. It still takes knowing how to read, doesn't it!! LOL.
Hey, of all people you know that isn't written in Latin. It's Wesleyism.....

[Bill Diehl]

Originally Posted by TILBURG

Sorry Bill I thought I read offset lifter? Never worked on a record setting canted valve motor before but sounds like some neat stuff.

It's all good I will post some pics in the build thread one of these days

[TILBURG]

Originally Posted by Bill Diehl

It's all good I will post some pics in the build thread one of these days

Cool I would really like that. Them canten valve motors really intrigue me.

[Larry Hill]

Do you think those canten valves will help my engine?