big base circle cam in stock elem.

[Bill Diehl]

Originally Posted by TILBURG

Sorry Bill I thought I read offset lifter? Never worked on a record setting canted valve motor before but sounds like some neat stuff.

It's all good I will post some pics in the build thread one of these days

[TILBURG]

Originally Posted by Bill Diehl

It's all good I will post some pics in the build thread one of these days

Cool I would really like that. Them canten valve motors really intrigue me.

[Larry Hill]

Do you think those canten valves will help my engine?

[TILBURG]

Originally Posted by Larry Hill

Do you think those canten valves will help my engine?

Not 100% on that one Larry. Would think youll have to buy new rockers. But if you run your VP clearance tight enough you might get the same effect.

[Ed Wright]

Originally Posted by tilburg

not 100% on that one larry. Would think youll have to buy new rockers. But if you run your vp clearance tight enough you might get the same effect.

lmbo!!

[Paul Iaconis]

Mr Tilberg can you get some pictures from Bill soon I will bring one of these canteen valved motors up to you this weekend. Look out stock eliminator here we come

Thanks in advance mr Bill

[TILBURG]

Originally Posted by Paul Iaconis

Mr Tilberg can you get some pictures from Bill soon I will bring one of these canteen valved motors up to you this weekend. Look out stock eliminator here we come

Thanks in advance mr Bill

Mr Iaconis please don't leave just yet!! Ive been googling the poop out of this deal and I'm not sure it can work. W/ the paulse width between the two springs I can't figure out how to get the pushrod phased w/ the lifter. But I can tell you WHEN we do your going straight to the top.