600++ HP 454 BBC

John N · 05-14-2007, 09:50 PM

600++ HP 454 BBC

This is a complete 454 motor that is ready for you to reassemble. Add a carb, wires, bearings and few gaskets and you're set to go 10s or better on pump gas.

It consists of the following:
-Gen VI 4 bolt main big block (standard bore)
-LS-6 pistons and pins
-Professionally resized 502 rods with ARP bolts
-Total Seal rings
-Isky roller cam (272-276@.050, 107lsa, 745-714 lift)
-Isky Red Zone lifters
-1.7 full roller rockers
-4" stroke crank
-World Merlin oval ports with a $1000 in a port and valve job (flow 335/250, 110cc chambers, 2.25/1.90 stainless steel valves, 7/16" studs and guide plates, Isky tool room springs and titanium retainers)
-Dart oval port single plane intake cnc ported for a 4150 carb
-Oil pan and new pump/pick up
Much more I probably forgot

I have a lot of pictures on my photobucket (don't want to kill your 56k with pics here!). Follow the link below...

---> ---> ---> http://s44.photobucket.com/albums/f11/SS86/454/

This is listed for a friend. If you have any questions you're best calling Jo, the owner, at 609-240-8546. Located in NJ. $3250 OBO! Thanks!

John
JohnNeville@Gmail.com
856 905 1908

05-14-2007, 09:50 PM	#1
John N Junior Member Join Date: Dec 2006 Location: 08080 South Jersey Posts: 63 Likes: 0 Liked 0 Times in 0 Posts	600++ HP 454 BBC 600++ HP 454 BBC This is a complete 454 motor that is ready for you to reassemble. Add a carb, wires, bearings and few gaskets and you're set to go 10s or better on pump gas. It consists of the following: -Gen VI 4 bolt main big block (standard bore) -LS-6 pistons and pins -Professionally resized 502 rods with ARP bolts -Total Seal rings -Isky roller cam (272-276@.050, 107lsa, 745-714 lift) -Isky Red Zone lifters -1.7 full roller rockers -4" stroke crank -World Merlin oval ports with a $1000 in a port and valve job (flow 335/250, 110cc chambers, 2.25/1.90 stainless steel valves, 7/16" studs and guide plates, Isky tool room springs and titanium retainers) -Dart oval port single plane intake cnc ported for a 4150 carb -Oil pan and new pump/pick up Much more I probably forgot I have a lot of pictures on my photobucket (don't want to kill your 56k with pics here!). Follow the link below... ---> ---> ---> http://s44.photobucket.com/albums/f11/SS86/454/ This is listed for a friend. If you have any questions you're best calling Jo, the owner, at 609-240-8546. Located in NJ. $3250 OBO! Thanks! John JohnNeville@Gmail.com 856 905 1908