|
|
![]() |
#1 |
Senior Member
Join Date: May 2020
Posts: 513
Likes: 545
Liked 494 Times in 241 Posts
|
![]()
A couple of (or three) thoughts...
1) I would think they should engage the full length of the splined area in the spool... How much spline is in the spool? 2) The other thing that occurs to me is the minimum would be at least the diameter of the axle... 3) If in doubt, call the manufacturer of the spool and axles. |
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Jun 2009
Location: Boulder City, Nevada 89005
Posts: 2,732
Likes: 2,798
Liked 2,479 Times in 697 Posts
|
![]()
The rule of thumb on fasteners is Thread engagement
should be the diameter of bolt. However, I do not advise less than double that with a spool. Unless of course, you like to knock down the Tree like I did some years ago at Winternationals.
__________________
John Irving 741 Stock 741 Super Stock |
![]() |
![]() |
Liked |
![]() |
|
|