plastic printing

[Ben Holt]

We have one and have been making quite a few parts with it. It is perfect for setup and/or temporary parts. We have made quite a few sets of runners for our comp car this year, we have even been running the runners down the track all year. Much cheaper than the billet aluminum runners we had made before...

That being said, you do need to be able to draw the part up, but that merely takes the program and some practice

[Chad Fergen]

We have 5 of them at work and they can make about anything you want but like said, someone needs to draw them up for you first. Ultem is one of the stronger materials you can get for that but its not as strong as aluminum.

[David Lee]

Originally Posted by Chad Fergen

We have 5 of them at work and they can make about anything you want but like said, someone needs to draw them up for you first. Ultem is one of the stronger materials you can get for that but its not as strong as aluminum.

can you tell me what printers you are using?


Thanks

[Myron Piatek]

I couldn't help but wonder if there is a compatible material that could be used in 3D printing to make replacement Thermoquad fuel bowls.

[David Lee]

Originally Posted by Myron Piatek

I couldn't help but wonder if there is a compatible material that could be used in 3D printing to make replacement Thermoquad fuel bowls.

find out what plastic was used and would be more than happy to investigate it.

[Myron Piatek]

Originally Posted by David Lee

find out what plastic was used and would be more than happy to investigate it.

I'll ask/check around. Don't know if it's accurate, but I've heard it referred to as "phenolic".

There is a source for small primary bowls for under $150, which I don't know if they are still being manufactured or there is just a large overstock. But no source for big primary bowls that I'm aware of.

[David Lee]

Originally Posted by Myron Piatek

I'll ask/check around. Don't know if it's accurate, but I've heard it referred to as "phenolic".

There is a source for small primary bowls for under $150, which I don't know if they are still being manufactured or there is just a large overstock. But no source for big primary bowls that I'm aware of.

i just joined a 3d printing forum and asked if there is any plastic that can stand being in contact with gasoline. i am going to take apasrt a junk tq i have and see what it looks like and what screw holes that would have to created. do you think having brass inserts for the screws to be needed?

[Chad Fergen]

Originally Posted by David Lee

can you tell me what printers you are using?


Thanks

All are Stratasys. The largest we can do is a 18 inch part.

[Chad Fergen]

Originally Posted by David Lee

can you tell me what printers you are using?


Thanks

If you are looking for an inexpensive printer to get started, let me know. "i got a guy" txt605-690-1240