1986 tpi 350

brian schuetta · 05-08-2018, 02:48 PM

Got the whole thing tore down, yes it was rebuilt. Two bolt block, one - piece rear seal, .060 over hyper pistons. The 261? heads are 1.72/1.5 valved with large chambers, totally useless except for shop cores. I plan to sell the TPI setup, manifold, runners, plenum, throttle body, and fuel rails. Those parts are from an 85-87 F-body. The bottom end will be cleaned up with new bearings/rings and sold either like that or running with different heads. I'm keeping the exhaust manifolds with the air tubes and connected lines for that system.

05-08-2018, 02:48 PM	#16
brian schuetta Member Join Date: Apr 2005 Location: san antonio tx Posts: 259 Likes: 5 Liked 28 Times in 15 Posts	Re: 1986 tpi 350 Got the whole thing tore down, yes it was rebuilt. Two bolt block, one - piece rear seal, .060 over hyper pistons. The 261? heads are 1.72/1.5 valved with large chambers, totally useless except for shop cores. I plan to sell the TPI setup, manifold, runners, plenum, throttle body, and fuel rails. Those parts are from an 85-87 F-body. The bottom end will be cleaned up with new bearings/rings and sold either like that or running with different heads. I'm keeping the exhaust manifolds with the air tubes and connected lines for that system.