79 Mustang project U/SA

RobbieRacer · 04-21-2017, 11:00 AM

I thought I would go ahead and post an update.It's been a while. I have made a little headway. I got the dash repaired, painted and installed. I mounted the seats on the factory seat rails. They were too wide at 14 inches but I swapped them from inside to outside and they are only 9 inches wide. I mounted the seats on plate steel then mounted them to the rails. It came out real good. Nice and solid.Also got the brakes done. Nothing fancy but they work. I might up grade them later.

04-21-2017, 11:00 AM	#11
RobbieRacer Member Join Date: Jul 2012 Location: Phoenix, Az Posts: 320 Likes: 17 Liked 118 Times in 41 Posts	Re: 79 Mustang project U/SA I thought I would go ahead and post an update.It's been a while. I have made a little headway. I got the dash repaired, painted and installed. I mounted the seats on the factory seat rails. They were too wide at 14 inches but I swapped them from inside to outside and they are only 9 inches wide. I mounted the seats on plate steel then mounted them to the rails. It came out real good. Nice and solid.Also got the brakes done. Nothing fancy but they work. I might up grade them later. Attached Thumbnails __________________ U/SA 79 Mustang