Team Woodfin's Bantam Roadster Build

Dragsinger · 01-02-2016, 07:36 PM

While Monte worked with the Super 10 block I kept busy with the Roadster's rocker arm set up and pushrod length checking.

*Note the intake lifter and rocker offset

*Note the cylinder head height. The head is a Brodix 11 degree casting worked by Kevin Self. As I began checking the pushrod length I quickly realized this head is not a typical small block head, it is very tall. To establish the proper pushrod length required using a BBC exhaust length checking pushrod!

01-02-2016, 07:36 PM	#10
Dragsinger VIP Member Join Date: Jul 2008 Location: Liberty City [East Texas] Posts: 1,760 Likes: 5 Liked 99 Times in 60 Posts	Re: Team Woodfin's Bantam Roadster Build While Monte worked with the Super 10 block I kept busy with the Roadster's rocker arm set up and pushrod length checking. Note the intake lifter and rocker offset Note the cylinder head height. The head is a Brodix 11 degree casting worked by Kevin Self. As I began checking the pushrod length I quickly realized this head is not a typical small block head, it is very tall. To establish the proper pushrod length required using a BBC exhaust length checking pushrod! Attached Thumbnails __________________ Larry Woodfin 471W