2 Step Wiring?

gmonde · 01-21-2009, 10:16 PM

you should be good,i dont read or see any thing about the roll control having to be on its own circuit ,you might have to throw in a diode to eliminate back feed (used this set up when i ran my nash 5 spd works slick) gmonde

Oct. 19. 2007: Final decision on two-step usage in Stock eliminator
After reviewing nearly 500 responses from Stock-category racers regarding the usage of two-steps in Stock Eliminator, the NHRA Technical Department has rendered a final decision. Effective for the 2008 season, two-steps will continue to be allowed in Stock eliminator but must be either clutch- or break pedal-mounted and/or -activated. No remote button locations will be allowed.

gmonde

01-21-2009, 10:16 PM	#2
gmonde Senior Member Join Date: Nov 2007 Posts: 615 Likes: 56 Liked 165 Times in 59 Posts	Re: 2 Step Wiring? you should be good,i dont read or see any thing about the roll control having to be on its own circuit ,you might have to throw in a diode to eliminate back feed (used this set up when i ran my nash 5 spd works slick) gmonde Oct. 19. 2007: Final decision on two-step usage in Stock eliminator After reviewing nearly 500 responses from Stock-category racers regarding the usage of two-steps in Stock Eliminator, the NHRA Technical Department has rendered a final decision. Effective for the 2008 season, two-steps will continue to be allowed in Stock eliminator but must be either clutch- or break pedal-mounted and/or -activated. No remote button locations will be allowed. gmonde