Lifters In Stock Eliminator

[Rick J]

Originally Posted by Barry Polley

If bigger diam lifters, bigger cam diam didn't work , SS,comp and Pro Stock would not have lifters over one inch diameter/ huge wheels and 70 plus?s mm cams. It is a performance advantage.

Yes, and if you can't increase cam core and/or lifter diameter, lofting the valvetrain reduces friction and adds hp, but some prefer keeping the lifter in constant contact with the lobe.

[Stan Weiss]

In a thread on another forum they were talking about that many years ago Isky sold "Chilled Iron lifters". If someone today could manufacture these it might solve the problem.


Stan

[Alan Roehrich]

The Isky chilled iron lifters are not harder than either the tool steel or the Johnson Hy-Lift hardened tappets. The only thing harder is carbide or ceramic.

[Stan Weiss]

Originally Posted by Alan Roehrich

The Isky chilled iron lifters are not harder than either the tool steel or the Johnson Hy-Lift hardened tappets. The only thing harder is carbide or ceramic.

Alan,
That was talked about in the pages I posted.


Stan

[Terry Cain]

Originally Posted by Alan Roehrich

The Isky chilled iron lifters are not harder than either the tool steel or the Johnson Hy-Lift hardened tappets. The only thing harder is carbide or ceramic.

Or Titanium

[Alan Roehrich]

Originally Posted by Terry Cain

Or Titanium

Titanium is entirely unsuited for a sliding interface application. Especially against cast iron or steel.