turbo 350

[pontiacchuck]

what code should i look for thank you chuck

[art leong]

Originally Posted by pontiacchuck

what code should i look for thank you chuck

Chuck if you are talking about a turbocharged car. I would be careful of the lightweight tricks. Many things that are done to fairly high power V8's won't stand the rapid torque of a quick spooling turbo.

[Mark Yacavone]

Originally Posted by pontiacchuck

what code should i look for thank you chuck

Like I was saying..It doesn't much matter..The later ones had more Torrington bearings .

If I was going to build a good one, I'd use parts from a T350 , T 250, and a 700R4 anyway
Depends on the application how many clutches you need ,where.
Can't help you any further without that.

[pontiacchuck]

et bracket car 80 pontiac grand prix 455 pontiac mild built 9 in ford rear end 3:70 gears 3200 with driver 3000 stall

[Mark Yacavone]

Originally Posted by pontiacchuck

et bracket car 80 pontiac grand prix 455 pontiac mild built 9 in ford rear end 3:70 gears 3200 with driver 3000 stall

In that case ,I'd build a 350C , 9 or 10 " conv. with a lock up clutch in it, 3.55 gears.
No need for the 700 and 250 parts...You can put and extra clutch in the direct if it makes you happy.
Full feed the direct drum, raise the pressure A LITTLE , hardened intermediate sprag race, (a must have), block the accumulators and the low gear blow off valve, drill a out few holes in the separator plate, and you got it.