64 Plymouth GT/EA in Ennis

chris3racing · 10-29-2009, 08:47 AM

I wish I had remembered this thread and printed it out before the East Coast Drag Times Reunion. Many of the historic cars, drivers and builders were there and I could have gotten some first hand opinions. I have heard all kinds of discussion about the steel hood with hinges, aluminum hoods with or without hinges and the troublesome fiberglass hood with a scoop.

Give up a couple of mopar secret I heard. Certains Mopar team would not park their car beside another similar car. NHRA didn't measure cars however, if you parked beside one the problem would be obvious.

Bolt at the bottom of the fender and a wrench in the car. Fenders were acid dipped so thin the fender would work loose during the run and had to be put back in position after each run.

10-29-2009, 08:47 AM	#10
chris3racing Senior Member Join Date: Mar 2008 Posts: 528 Likes: 0 Liked 0 Times in 0 Posts	Re: 64 Plymouth GT/EA in Ennis I wish I had remembered this thread and printed it out before the East Coast Drag Times Reunion. Many of the historic cars, drivers and builders were there and I could have gotten some first hand opinions. I have heard all kinds of discussion about the steel hood with hinges, aluminum hoods with or without hinges and the troublesome fiberglass hood with a scoop. Give up a couple of mopar secret I heard. Certains Mopar team would not park their car beside another similar car. NHRA didn't measure cars however, if you parked beside one the problem would be obvious. Bolt at the bottom of the fender and a wrench in the car. Fenders were acid dipped so thin the fender would work loose during the run and had to be put back in position after each run.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode