|
|
04-03-2024, 04:20 PM
|
#1 |
|
Junior Member
Join Date: Mar 2015
Posts: 13
Likes: 0
Liked 19 Times in 4 Posts
|
Ss gt/ta-d
If I understand the Class Racer Info site correctly...
A 91-93 Ranger can run in SS GT/TA through D depending on engine combo. Is this is a possibility? Brad Last edited by bpete; 04-03-2024 at 04:44 PM. Reason: text |
|
|
|
04-03-2024, 06:18 PM
|
#2 |
|
Member
Join Date: Aug 2009
Location: howell,nj
Posts: 124
Likes: 299
Liked 53 Times in 11 Posts
|
Re: Ss GT/TA-D
You are correct. They did away with the 250lb + or - a few years back in GT
|
|
|
|
|
04-03-2024, 09:29 PM
|
#3 |
|
Member
Join Date: Sep 2006
Location: Prunedale Ca
Posts: 184
Likes: 507
Liked 381 Times in 76 Posts
|
Re: Ss GT/TA-D
Not sure I have seen a ford ranger in the GT class, that would be cool, hope you can make it happen. John
|
|
|
|
|
04-04-2024, 10:26 AM
|
#4 |
|
Junior Member
Join Date: Mar 2015
Posts: 13
Likes: 0
Liked 19 Times in 4 Posts
|
Re: Ss GT/TA-D
I need to look into it a bit further.
I have a donor chassis. Some of the aluminum replacement heads look like they are not available for some combinations. Acceptable cross-member modifications are also of a concern. IE what can be trimmed and or replaced within the class guidelines.. Brad |
|
|
|
|
04-05-2024, 09:20 AM
|
#5 |
|
Senior Member
Join Date: Sep 2016
Posts: 875
Likes: 194
Liked 300 Times in 168 Posts
|
Re: Ss GT/TA-D
You need to maintain the upper and lower control arms, otherwise cut out and trim as much as you need for clearance. However you will need to add reinforcement, as a tube/plate under the oil pan.
|
|
|
|
 |
|
|
Linear Mode
