CLASS RACER FORUM - View Single Post

rx dealer · 12-09-2019, 06:58 PM

I did not run a mid plate. I had steel tubing about 1/2 inch in diameter, with hiem joints on each end. one end went to the trans cross member and the other end on the clutch can. this was hooked up on the passenger side of the car. it's simple and rock solid. Luke

12-09-2019, 06:58 PM	#1
rx dealer Member Join Date: Mar 2007 Location: Lake Orion, Michigan Posts: 337 Likes: 12 Liked 53 Times in 13 Posts	Re: Mid plate Stick car I did not run a mid plate. I had steel tubing about 1/2 inch in diameter, with hiem joints on each end. one end went to the trans cross member and the other end on the clutch can. this was hooked up on the passenger side of the car. it's simple and rock solid. Luke