View Single Post
Old 01-29-2013, 01:10 PM   #14
dartman
Member
 
dartman's Avatar
 
Join Date: Oct 2005
Location: N.S. CANADA
Posts: 498
Likes: 160
Liked 68 Times in 41 Posts
Default Re: exhaust cross over (heat riser) fill

Quote:
Originally Posted by FSA1673 View Post
Correct, I was under the impression as long as it does not protrude into the valve pocket you are OK. Exhaust runner volume still needs to meet minimum spec. Not sure how you would measure it it if was not filled.

Adam good to hear it is worth power.

Scott

page xv under "HOW TO USE THIS RULEBOOK" in the rule book


On the other hand, as to performance equipment, it is the
general rule that unless optional performance equipment or
performance-related modification is specifically permitted by
this Rulebook, it is prohibited. All model, engine, or equipment
changes or modifications not specifically addressed in this
Rulebook must be submitted in writing to NHRA for
consideration prior to competition. Approval will be granted or
denied in NHRA’s sole and absolute discretion. The applicant
will be notified of approval or rejection in writing from NHRA
headquarters in Glendora, Calif.


as I read it "Blocking passage down in valve pocket prohibited."I have not seen any where in the book that says "I was under the impression" lol
__________________
1231 FS/D Drag Pak
1231 E/SA 71 Demon
Kelly MacKay

Last edited by dartman; 01-29-2013 at 02:17 PM.
dartman is offline   Reply With Quote