|
![]() |
#1 |
Junior Member
Join Date: Aug 2013
Location: mars hill me.
Posts: 15
Likes: 0
Liked 13 Times in 3 Posts
|
![]()
can the roll bar /cage go through the firewall and extend into frnt suspension , strut tower area in stock eliminator ? I did not think this was legal in stock , but was at a div. 1 race and saw this on a couple cars .
|
![]() |
![]() |
Liked |
![]() |
#2 |
VIP Member
Join Date: Nov 2001
Location: The Lowcountry.
Posts: 2,954
Likes: 2,536
Liked 2,610 Times in 948 Posts
|
![]()
With what Stock Eliminator has become I'm all good with this, just put the damn battery in the trunk!
|
![]() |
![]() |
![]() |
#3 |
VIP Member
Join Date: Jun 2009
Location: Boulder City, Nevada 89005
Posts: 2,719
Likes: 2,765
Liked 2,425 Times in 687 Posts
|
![]()
Yep
There was a rule change a few years ago.
__________________
John Irving 741 Stock 741 Super Stock |
![]() |
![]() |
Liked |
![]() |
#4 |
Member
Join Date: Mar 2021
Posts: 124
Likes: 0
Liked 51 Times in 30 Posts
|
![]()
2021 rule book "front braces may not extend in front of firewall"
|
![]() |
![]() |
![]() |
#5 |
Member
Join Date: Jul 2016
Posts: 389
Likes: 1,655
Liked 753 Times in 213 Posts
|
![]()
Just go to STOCK rules, section 11A, on page 10 in the FIREWALL section and you will have the specs/info/answer to your question regarding the front tubes.
Keep on, Charles Stewart |
![]() |
![]() |
![]() |
#6 |
VIP Member
Join Date: Feb 2003
Location: Glendale, Arizona
Posts: 3,036
Likes: 710
Liked 1,538 Times in 575 Posts
|
![]()
Not applicable if you have a roll cage.
Stock Cars Section 11A, page 10 and page 11 BODY: 7, FIREWALL "Alterations prohibited unless expressly permitted in this section. Firewall coverings prohibited. Where heater/air conditioning units have been removed, area must be covered with minimum .024-inch steel or .032-inch aluminum, including rear hood seal/ flange, as on GM A-body. Minor firewall modifications permitted to C5 and C6 Corvettes for transmission installation. Roll cage tubing may run across top or side of inner fender well/strut tower and attach to frame horn. See General Regulations 7:4." |
![]() |
![]() |
![]() |
|
|