MSD Crank Trigger w/ Accel DFI 7 on LT1

Jason Leindecker · 05-13-2009, 12:33 PM

I have just added a Crank trigger, 6al, and coil to eliminate previous problems with the MSD Lt1 distributor. I disconnected the distributor and only have the coil wire going to it. I have plenty of spark at both the coil and the plug. Now i dont have fuel ( i have 60 lbs of FP @ regulator). I am assuming the DFI needs a signal from the ignition to fire the injectors (batch fire). If so how does this get wired.

Thanks
Jason

05-13-2009, 12:33 PM	#1
Jason Leindecker Junior Member Join Date: Feb 2006 Location: Center Valley, PA Posts: 18 Likes: 0 Liked 0 Times in 0 Posts	MSD Crank Trigger w/ Accel DFI 7 on LT1 I have just added a Crank trigger, 6al, and coil to eliminate previous problems with the MSD Lt1 distributor. I disconnected the distributor and only have the coil wire going to it. I have plenty of spark at both the coil and the plug. Now i dont have fuel ( i have 60 lbs of FP @ regulator). I am assuming the DFI needs a signal from the ignition to fire the injectors (batch fire). If so how does this get wired. Thanks Jason __________________ Jason Leindecker