Mopar A Body/B-RB Engine racers ???

[David Lee]

Originally Posted by Old Yellow RR

Anyone have recent experience using a commercially available header on a B/RB engine in Stock Eliminator? Trying to avoid having headers made on the car, looking for something that will bolt on.



Thanks

dart or cuda? the only ones i know about are fenderwell headers

[Chipper Chapman]

TTI or ARH? I know TTI sells them

[Old Yellow RR]

Originally Posted by David Lee

dart or cuda? the only ones i know about are fenderwell headers

1967-1976 A Body - both Dodge and Plymouth, have the same engine compartment layout. Don't want fenderwell headers.


Thanks.

[GTX JOHN]

I run 2 Inch under chassis headers by TTI on my
10 Second 1969 A Body Valiant.

I can check the number on them when I get back from Division 7
races next week.

There are several Fender well Headers for that combo but they are
all a pain for tire clearance!

They are expensive!

[Coleydog]

For the life of me I can’t remember the name but there were sets made where 3 tubes where inside the frame and one went out the front end alignment hole back under the car, they fit well with no cutting. Maybe someone else can remember

[e vassar]

Originally Posted by Coleydog

For the life of me I can’t remember the name but there were sets made where 3 tubes where inside the frame and one went out the front end alignment hole back under the car, they fit well with no cutting. Maybe someone else can remember

McCandless?

[James L Miller]

Pro Parts used to make some nice RB headers for an A-body.

Jeff Ross had some nice headers for sale on Face Booger.

[Cotten]

Originally Posted by Coleydog

For the life of me I can’t remember the name but there were sets made where 3 tubes where inside the frame and one went out the front end alignment hole back under the car, they fit well with no cutting. Maybe someone else can remember

I had a set of Jardines like that. In the previous century lol

[Coleydog]

Originally Posted by Cotten

I had a set of Jardines like that. In the previous century lol

‘Pro Parts’ sounds right. It WAS last century lol, a friend put them on his 71 dart, 440 engine around 1990 or so fit much better than the fender wells.

[Gmirza]

I have a set of parts pro headers on a 75 duster 383. Two tubes go through the fender well on the driver side one on the passenger side. Fit well and will work with power steering. May be big for a stocker, 2”-21/8” with 3.5” collector. Bob Mazzolini used to sell them.