Mopar Build - DF/S Neon

HR3128 · 07-03-2021, 09:20 PM

Just a quick update on my project – Badly rusted K-frame has been replaced. 20 year-old rusted bolts made this way more of a job than it should have been. But it’s done along with new axles, new front brake calipers, rotors, pads, struts & tie-rod ends. I did drive it around the sub a little today (no plates yet). All seems OK so far.
I have not been able to find any tuner software for this car. The 2003 Neon R/T is a one year only ECM. I have found a place that will sell a re-programmed ECM but not tuning software.
The next step is to take it out for some “test & tune” runs.

07-03-2021, 09:20 PM	#8
HR3128 Junior Member Join Date: Jan 2021 Location: SE Michigan Posts: 23 Likes: 0 Liked 54 Times in 8 Posts	Re: Mopar Build - DF/S Neon Just a quick update on my project – Badly rusted K-frame has been replaced. 20 year-old rusted bolts made this way more of a job than it should have been. But it’s done along with new axles, new front brake calipers, rotors, pads, struts & tie-rod ends. I did drive it around the sub a little today (no plates yet). All seems OK so far. I have not been able to find any tuner software for this car. The 2003 Neon R/T is a one year only ECM. I have found a place that will sell a re-programmed ECM but not tuning software. The next step is to take it out for some “test & tune” runs.