|
03-29-2019, 03:57 PM | #71 |
Senior Member
Join Date: Jul 2014
Posts: 569
Likes: 36
Liked 50 Times in 35 Posts
|
Re: Rockers for stock Eliminator 5.0 SBF
On the HP increase, and not sure how the ford rockers look, but on a small block Mopar, Comp claimed 20-30 HP increase using their roller tip steel shaft rockers over the stock stamped ones.?
Mike |
03-31-2019, 12:19 PM | #72 |
VIP Member
Join Date: Oct 2008
Posts: 2,116
Likes: 1,078
Liked 181 Times in 111 Posts
|
Re: Rockers for stock Eliminator 5.0 SBF
Have an LT1 with SA Stock Rockers on 7/16 stud.
They do not need push rod guides. Is there any performance advantage going to a Roller Tip or full Roller Rocker? I have a set of 1.6 GM SA Roller Rockers. Can the Cam be ground and use the 1.6 GM RR’s if it meets Lift Requirements? |
03-31-2019, 12:51 PM | #73 | |
VIP Member
Join Date: Dec 2004
Location: Cumming GA
Posts: 1,946
Likes: 1,132
Liked 1,317 Times in 264 Posts
|
Re: Rockers for stock Eliminator 5.0 SBF
Unless your combo came with 1.6 they are not legal. Whenever someone asks for a performance gain report on one part, the answer would be no. The entire combo needs to be considered. Especially cam and springs lifters pushrods etc. when you are talking legal stocker parts, it all has to work together.
Quote:
__________________
James Schaechter 3163 STK |
|
Liked |
04-02-2019, 11:24 AM | #74 |
Member
Join Date: Apr 2004
Posts: 172
Likes: 0
Liked 29 Times in 15 Posts
|
Re: Rockers for stock Eliminator 5.0 SBF
PRW's are pretty good. We sold a few sets of the stainless units and had them NHRA approved. I actually have a 1.5 ratio set for some dumb reason. Must have been spare shelf parts......... like the Sherman lifters..........
Our shelf did ban them to a specific corner............ |
|
|