Qjet Question

[Mike Pearson]

Originally Posted by Robert Simpson

Update. Removing the spring on the secondary shaft and pinning it was the key. I made a pass last weekend and drove past the finish line and pedaled it a couple times and it worked. I dial honest but now I know if I need to pedal it should respond ok. Thanks to all the suggestions it is appreciated. Now if I can just figure out how to lean up the mid range it would be good, any suggestions out there on that?

Robert

Are you still using the metering rods in the primary jets. If so most are not using them any more. Drop down about 5 jet sizes on the primary jets and remove the primary metering rods and plug the hole where the power valve used to be. That should give you better control of the fuel metering