FS/H Cobra Jet Body In White Project

George Wright · 11-30-2014, 06:47 PM

Some more progress on the CJ.

Test fit the dash frame.

Bar under the dash was fit, located and tack welded in.

Back brace bar and bars to 3 link upper mount were fit and located.

Side door bars were fit and located.

At this point all of the roll cage bars have been fit and located. I will wait on welding the back brace and side bars until I finish up patching some holes in the floor and cutting the floor for transmission and shifter access.

Mitch, you will see this car at Milan. I will most likely make my first test runs there.
Bob, it was nice meeting you.
Jerry, did you get my reply several weeks ago with my number? Bill never called.

11-30-2014, 06:47 PM	#5
George Wright Member Join Date: Nov 2002 Location: Michigan Posts: 184 Likes: 10 Liked 390 Times in 34 Posts	Re: FS/H CobraJet Body In White Project Some more progress on the CJ. Test fit the dash frame. Bar under the dash was fit, located and tack welded in. Back brace bar and bars to 3 link upper mount were fit and located. Side door bars were fit and located. At this point all of the roll cage bars have been fit and located. I will wait on welding the back brace and side bars until I finish up patching some holes in the floor and cutting the floor for transmission and shifter access. Mitch, you will see this car at Milan. I will most likely make my first test runs there. Bob, it was nice meeting you. Jerry, did you get my reply several weeks ago with my number? Bill never called. __________________ George Wright https://9500rpm.com