Smith Machine Ceramic llifters...

B Aceves · 07-08-2013, 01:19 PM

Quote:

Originally Posted by Bill Edgeworth

To my knowledge Trend does not make a Pontiac lifter. Pontiac lifters are the same diameter as a Chevy but Pontiac ones are taller. Putting a Chevy lifter in a Pontiac can cause the oil gallery to become exposed at the top of the lifter when the lifter is on the base circle and or the lifter oil groove to become exposed on the bottom side. I can’t remember which it is, it’s been a few years since I decided to see if Chevy ones would fit. I would just use the Sherman lifters. If you really want to use ceramics I have a used set. I quit using ceramics years ago.

Hey Brent X 2 on the Shermans have well over 100 passes on mine no issues !!!

B Aceves · 07-08-2013, 01:24 PM

Quote:

Originally Posted by B Aceves

Hey Brent X 2 on the Shermans have well over 100 passes on mine no issues !!!

Used cam or not with a new lifter using a good BR fluid for a few passes will not hurt one bit and will make make you feel a little more at ease as well. Gibbs makes two different BR oils and works fine IMO.

07-08-2013, 02:01 PM

Quote:

Originally Posted by B Aceves

Hey Brent X 2 on the Shermans have well over 100 passes on mine no issues !!!

Is a Sherman lifter just a limited travel stock lifter? I guess you have to cut way back on spring pressure with those?

brent flynn · 07-08-2013, 09:22 PM

Quote:

Originally Posted by B Aceves

Hey Brent X 2 on the Shermans have well over 100 passes on mine no issues !!!

As Todd Hoven asked, will i need to run 130-ish on the seat? And what roughly , do these run, cost wise? They may be the way to go...do they lash, like a Schubeck? or do you preload them, a little?

B Aceves · 07-11-2013, 11:28 AM

Quote:

Originally Posted by brent flynn

As Todd Hoven asked, will i need to run 130-ish on the seat? And what roughly , do these run, cost wise? They may be the way to go...do they lash, like a Schubeck? or do you preload them, a little?

Brent, I would suggest a phone call to them and talk with them about the do and don't with their lifters he will talk with you and then you can decide what your comfort level would be with adjustment, spring psi , etc.

brent flynn · 07-14-2013, 02:02 PM

Thanks Bob!

07-14-2013, 02:02 PM	#6
brent flynn Senior Member Join Date: Apr 2011 Location: Middletown, IN Posts: 593 Likes: 0 Liked 0 Times in 0 Posts	Re: Smith Machine Ceramic llifters... Thanks Bob! __________________ 1968 Bird/TRW 455/Home ported 13's, '70 Qjet,Holley Street Dominator manifold, Comp Solid FT, 10.817/122.30/1.440 Workin' on E/SA combo 3119 E/SA