Mopar Ball Joints

magnumv8 · 11-10-2012, 12:58 PM

The old school front end shop fix for this is pretty simple.....all you need to do is with a small hammer take and tap the ball joint flange in the A arm reducing it's diameter to the point where the bottom of the new ball joint still slips in but the threaded portion does not.....screw in the new ball til it seats then put a couple small tack welds on it and you are done......

D L Rambo STK 1300

11-10-2012, 12:58 PM	#3
magnumv8 Member Join Date: Feb 2009 Location: Coraopolis, Pa. Posts: 172 Likes: 0 Liked 0 Times in 0 Posts	Re: Mopar Ball Joints The old school front end shop fix for this is pretty simple.....all you need to do is with a small hammer take and tap the ball joint flange in the A arm reducing it's diameter to the point where the bottom of the new ball joint still slips in but the threaded portion does not.....screw in the new ball til it seats then put a couple small tack welds on it and you are done...... D L Rambo STK 1300