Quote:
Originally Posted by Tar Heel
I picked up a new gear for my C5 that I'll install this winter in preparation to run Pure Stock next year. Many Corvette guys buy micropolished gears but this one is not done already. Where can I get it done or is there a better "treatment" to do before installation? Also, is it worth the time and effort or just install it as is?
|
As Is , is lumpy.
Get a large lathe file (single cut fine) and draw file the flange face of the crown gear to get the lumps/burrs off around the bolt holes. Use the same file to go over the spool flange to get the lumps off there.