|
|
![]() |
#1 |
VIP Member
Join Date: Mar 2002
Posts: 1,102
Likes: 56
Liked 464 Times in 113 Posts
|
![]()
I used to use the Joe Gibbs XP-1 5-20. Never again. Extreme sludge created by this oil pluging oil filters. Just about cost me an engine. Now I use 10-30 Valvoline race oil. No issues and runs clean.
__________________
68 Chevy11 327 F/S |
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Mar 2010
Location: Newport News, VA
Posts: 1,435
Likes: 371
Liked 129 Times in 59 Posts
|
![]()
I just started using the Amsoil Dominator Racing 10W30 this weekend after finishing with the break-in oil, Brad-Penn 30W. I've noticed that the oil pressure has increased over the conventional oil, so much that I may have to go to a 5W20 to keep the pressure down. I'll know more after the first change when I can compare each oil.
Lew
__________________
Lew Silverman #2070 "The Wagon Master" N/SA |
![]() |
![]() |
![]() |
#3 |
Member
Join Date: Jul 2007
Location: Georgia
Posts: 158
Likes: 2
Liked 31 Times in 10 Posts
|
![]()
This year I've mainly ran Valvoline 10-30 Vr1 conventional oil with great results. I cut apart my filter every 25 runs and saw hardly any material. 190+ runs so far this year changing it every 25 to 30 runs because it loses so much oil due to low ring tension (my fault).
Last year I used Royal Purple XPR 0-10 and it too worked awesome changing it every 50+ runs. 210+ runs last year on the engine and the bearings looked almost perfect. On top of that the Royal purple is a tenth faster in my engine. Both oils are awesome and I recommend them to all* *455 Pontiac Stock Eliminator Engine - The highest RPM it sees is 6100
__________________
Michael Brand II 505B - F/SA |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Nov 2005
Location: Verrry South Jersey
Posts: 537
Likes: 134
Liked 251 Times in 125 Posts
|
![]() |
![]() |
![]() |
![]() |
#5 |
Member
Join Date: Nov 2005
Location: cloquet mn
Posts: 465
Likes: 17
Liked 66 Times in 29 Posts
|
![]()
There was a good post on speedtalk a while back about VR1, and a guy on there who
is a independent oil analist/engineer tested 50 top oils for lack of wear #1 ding ding ding Pennzoil Platinum, then amsoil dominator then lucas racing oil!!! Now with real world racing experience i will say there are quite a few oils that perform well for anti wear that are not fast but will keep your stuff alive. As far as fast oils you got Royal purple, Red line Gibbs, Lucas and im sure some others, one thing i tried that was reasonably fast was using 4qts of kendall conventional 5/20 with 16oz of lucas breakin additive. I have used some of the other high ranked anti wear oils with good success for keeping stuff alive but performance suffered considerably, i can say for sure that there is a solid .15 to .20 from best to worst.
__________________
Ron Mattson 5015 STK |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Jul 2007
Posts: 578
Likes: 0
Liked 3 Times in 1 Post
|
![]()
I had the same, grey sludge with the RP 5w20, both the reg and XPR, didnt matter. It never would "mix" back in. When we first built the car and were hammering on the engine, we had it out often and found the same thing everytime. I would clean in out completely and find it again the next time.
Good discussion guys, what have some of the rest of you found? I know the Gibbs is common in SS, any lifter pump up issues with the thinner weights in Stock? Wade |
![]() |
![]() |
![]() |
#7 |
VIP Member
Join Date: Nov 2009
Location: Egg Harbor Township, NJ
Posts: 1,467
Likes: 1,444
Liked 4,365 Times in 501 Posts
|
![]()
Used Red Line 20w synthetic race oil for last two years until I won the stock/super stock race at Maple Grove and Jeff Kundratic gave me a buy one/get one on some Lucas Race oil (10w30 conventional) that I put in the car for the Dutch. I heard you had to change Gibbs very often, I usually change my filter every 2-3 races and the oil 2-3 times a year or every 20 runs.
|
![]() |
![]() |
![]() |
#8 |
Live Reporter
Join Date: May 2006
Location: Dripping Springs, Tx
Posts: 2,709
Likes: 186
Liked 520 Times in 132 Posts
|
![]()
Bobby or anyone else I just bought some Redline 20W. Always ran Mobil 1 before. Has this been a good oil for those that had used it. Got Gibbs break in oil in it now. Hoping to make a pass soon. Lol
__________________
Ed Carpenter 2005 Chevy Cobalt A/SM Race Engine Development |
![]() |
![]() |
![]() |
#9 |
Junior Member
Join Date: Jun 2007
Posts: 64
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
Anybody using swepco 5/30 in ss engines?
|
![]() |
![]() |
![]() |
#10 |
Junior Member
Join Date: Feb 2004
Location: Oregon City, Or
Posts: 16
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
Really interesting reading here.
__________________
2001 Division 6 S/ST Champion 2002 Jegs Allstar 2010 Woodburn Dragstrip S/P Track Champion |
![]() |
![]() |
![]() |
|
|