|
|
![]() |
#1 |
Member
Join Date: Jan 2005
Location: Lake Tapps, Washington
Posts: 137
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
Is this a "pop quiz"? I really hate pop quiz's!
|
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Dec 2001
Location: Texarkana Ark/TX
Posts: 2,446
Likes: 575
Liked 880 Times in 311 Posts
|
![]()
Heckeee durn it....I guess that is telling me to toss the old faitful Champion spark plug blaster. OH, Well!!
__________________
Adger Smith (Former SS) |
![]() |
![]() |
![]() |
#3 |
Member
Join Date: Dec 2008
Posts: 100
Likes: 0
Liked 1 Time in 1 Post
|
![]()
Don't forget that the service/replace cycle of any part or assembly in a race car is established by advice or practical experience. Aluminum rods, ring and pinion, and all wear/breakage prone components have a car/engine combination specific "replace" number of runs to ensure a minimum number of failures and or loss of performance. Although a single additional run over a valid cycle number is very rarely going to result in a failure, adhering to a schedule is simply good procedure that results in fewer "surprises". A far as spark plugs are concerned they have been cycled in the past rather than properly cleaned and dressed because they were frequently part of a parts deal and were free. Once plug cost is out of pocket Adger's method is a good cost cutting procedure to lengthen (not eliminate) the cycle number. (As long as you are not paying retail shop labor rates!!! lol)
You want to be sure not to get to the point like the guy who took such long steps to save wear and tear on his $40 shoes that he wound up splitting his $75 pants.....a round loss due to falling off a few hundredths because of overused spark plugs would fall in that category. Last edited by Jim B; 11-30-2011 at 02:51 PM. |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Dec 2001
Location: wv
Posts: 884
Likes: 42
Liked 56 Times in 21 Posts
|
![]()
my plugs have been in the mustang since 2003
__________________
Vic Guilmino 1129 STK |
![]() |
![]() |
![]() |
#5 |
VIP Member
Join Date: Jan 2003
Location: Allentown,PA
Posts: 2,474
Likes: 885
Liked 858 Times in 234 Posts
|
![]()
but you change rocker arms every other run!!
__________________
Tom Goldman 1500 SG , 1506 STK |
![]() |
![]() |
![]() |
#6 |
VIP Member
Join Date: Oct 2002
Location: Greater Boston
Posts: 1,495
Likes: 1,113
Liked 900 Times in 191 Posts
|
![]()
Maybe not with the new rocker arm rule!
__________________
Bob Don 128 SS Last edited by Bob Don; 11-30-2011 at 05:48 PM. |
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Dec 2002
Posts: 915
Likes: 1,127
Liked 680 Times in 203 Posts
|
![]()
I saw a S/S hemi pick up 50 horsepower on the dyno last summer with a set of fresh NGK plugs. Not mine. Dyno
|
![]() |
![]() |
![]() |
|
|