Balancer is "friction welding"

Run to Rund · 08-22-2011, 11:12 AM

The pushrods could hurt only if you are getting valve float, not real likely unless you were right at the edge before. I'd look to the damper first. Are you holding the engine rpm against the rev limiter? Could that be introducing vibrations?

joespanova · 08-22-2011, 11:19 AM

Quote:

Originally Posted by Run to Rund

The pushrods could hurt only if you are getting valve float, not real likely unless you were right at the edge before. I'd look to the damper first. Are you holding the engine rpm against the rev limiter? Could that be introducing vibrations?

2 step........

high side chip is 8800

low side ( launch ) is 7000........I am on the low side chip at launch.

08-22-2011, 11:12 AM	#1
Run to Rund Senior Member Join Date: Sep 2007 Location: Henderson, NV Posts: 583 Likes: 8 Liked 54 Times in 27 Posts	Re: Balancer is "friction welding" The pushrods could hurt only if you are getting valve float, not real likely unless you were right at the edge before. I'd look to the damper first. Are you holding the engine rpm against the rev limiter? Could that be introducing vibrations?