|
05-08-2011, 06:36 PM | #1 |
VIP Member
Join Date: Jan 2003
Location: jackson
Posts: 1,165
Likes: 0
Liked 5 Times in 3 Posts
|
Cam question/help
I bought a 305 out of an 81 Z-28 the cam that was in it was a Crane part # 11-41-84 grind # ssh-310-nc I can't find any info on it.....anyone know what it is?
__________________
Greg Fulk 308 308X P/SA "ALL AMERICAN" |
05-08-2011, 07:06 PM | #2 |
VIP Member
Join Date: Apr 2002
Location: Coarsegold, CA
Posts: 1,017
Likes: 57
Liked 321 Times in 101 Posts
|
Re: Cam question/help
Hi,
I found this on the Nasty Z28 website.... I don't know if info is correct???????????? Crane 114051 SSH-310-NC, hydraulic, rough idle, good midrange hp Intake Open-Close BTDC-ABDC 40-90 Exhaust Open-Close BBDC-ATDC 88-42 Degrees Advertised Duration Int. 310 Exh. 310 Degrees Duration @ .050 Cam Lift Int. 236 Exh. 236 Running Clearance Hot Int .000 Exh. .000 Gross Valve Lift Int. .485 Exh. .485 RPM Range min 3800 max 6800 valve float 7000 Good luck, Bob
__________________
Bob Mulry 7516 STK A & M Motorsports |
05-08-2011, 08:11 PM | #3 |
VIP Member
Join Date: Jan 2003
Location: jackson
Posts: 1,165
Likes: 0
Liked 5 Times in 3 Posts
|
Re: Cam question/help
Humm I just check lobe lift it was .314 that would make it 470 with a 1.5 rocker. Thanks for the info Bob
__________________
Greg Fulk 308 308X P/SA "ALL AMERICAN" |
|
|