Holley Carb Question

[Bub Whitaker]

Originally Posted by Adger Smith

I sold a few of those secondary kits. Marketed by Eelco (sp?)
I guess that makes me in the really old, right Bill? :~)
If tech didn't like them fill with a little epoxy or JB weld.

Yes ur old... installed that kit on my L79 66 Chevy II...

[BlueOval Ralph]

Still have one in my old Holley parts, the gear drive and the squirter Y

Originally Posted by Bub Whitaker

Yes ur old... installed that kit on my L79 66 Chevy II...

[X-TECH MAN]

Originally Posted by BlueOval Ralph

Still have one in my old Holley parts, the gear drive and the squirter Y

I had one on my new at the time 68 Z-28. The car had zero torque with the factory 3.73 gears, 2.20 low gear trans and by going to a manual secondary set up with the squirters it ran better on the street. The 5:38 gears made it run even better but it was rough to drive on the Washington D.C. beltway with those gears.

[blasttime]

Them there holes is for bolting chain to yank engine

[Mike Gray]

Div. tech director said okay as long as I don't grind the divider plate to clean up around the holes.

[John Lang]

Originally Posted by Bub Whitaker

Yes ur old... installed that kit on my L79 66 Chevy II...

You guys think your old ! Just the other day I was digging around in some old boxes of carb parts, and came across the kits your talkimg about, with the gear drive, the long squirters, etc, and I thought I was old ! John...........