Super Stock Heads

[VF17]

In need of recommendations for shops that specialize in building and repairing aluminum and/or cast iron chevy small block heads for NHRA Super Stock.
Contact info would be great too.
Thanks

[Kevin Panzino]

As far as cast iron repair, and the welding/brazing up of exhaust port floors, the master is Robert Ray.
Ray?s Cracked Head Repair , Seymour Indiana
812-521-0046
Be prepared to wait a bit and it?s not cheap. But he has a furnace where he puts the entire head, gets it well over 1,000f and has sliding panels to reach in and weld/braze, then pause and let it soak. Absolutely critical to avoid cracking the poop out of cast iron.

Kp

[VF17]

Thank you

also looking for shops that do complete cylinder heads, intakes etc.

also interested in info on complete engines

[SS3860]

Heads up heads.
Dayton Ohio

Tom Flowers
3860 E/SA

[VF17]

Originally Posted by Kevin Panzino

As far as cast iron repair, and the welding/brazing up of exhaust port floors, the master is Robert Ray.
Ray?s Cracked Head Repair , Seymour Indiana
812-521-0046
Be prepared to wait a bit and it?s not cheap. But he has a furnace where he puts the entire head, gets it well over 1,000f and has sliding panels to reach in and weld/braze, then pause and let it soak. Absolutely critical to avoid cracking the poop out of cast iron.

Kp

Do they work on aluminum heads??

[Kevin Panzino]

Not sure about that. I would certainly think they would. But aluminum is much easier. Plenty of good tig welders could handle that. Then just use your head guy of choice to clean up chamber and put new seats in.

Kp

[VF17]

Originally Posted by Kevin Panzino

Not sure about that. I would certainly think they would. But aluminum is much easier. Plenty of good tig welders could handle that. Then just use your head guy of choice to clean up chamber and put new seats in.

Kp

That's what I'm looking for - head guys that do SS heads !

[Tom Meyer]

Originally Posted by VF17

That's what I'm looking for - head guys that do SS heads !

Be prepared to wait over a year to get a set of heads, most good head guy are on have waiting list. Tom

[J.R. Haddad]

If they are aluminum heads, check with Carl Foltz @ CFE. With his machinery and manpower, the wait might not be as long.

J.R.

[VF17]

Originally Posted by Tom Meyer

Be prepared to wait over a year to get a set of heads, most good head guy are on have waiting list. Tom

I do appreciate that info but I am looking for recommendations, names, not wait times.