Thread: Wheel Studs
View Single Post
Old 03-01-2019, 04:31 PM   #22
gsa612
Senior Member
 
gsa612's Avatar
 
Join Date: Jan 2008
Location: 100th Meridian
Posts: 569
Likes: 116
Liked 280 Times in 139 Posts
Default Re: Wheel Studs

Quote:
Originally Posted by Mike Pearson View Post
I don't know about Moser but Strange will drill and tap their axles from 1/2 to 5/8 as long as the have not been welded on, Studs tacked etc. I had mine done by Strange about ten years ago and the cost was minimal. They fit the wheels perfectly when I got them back. Turn around was very quick as well.
He's going to need 10 new holes indexed,drilled and tapped.The current knurled stud hole is bigger than a 5/8 threaded stud.Hope it don't have 1" lightening holes between the existing holes then your SOL. gsa612
gsa612 is offline   Reply With Quote