CLASS RACER FORUM - View Single Post - Any machinists set valves on an DOHC motor?

Rich Biebel · 04-09-2011, 05:02 PM

Get a pair(1 Int and 1 ex) set at the valve to whatever lash you want and then see what it is between the cam and the roller. A feeler gauge should work ......Once you know the number that is at the cam/roller with the proper lash at the valve tip..... set them all at the cam/roller contact area. They do make very thin open end wrenches once know as tappet wrenches that might work on the adjusters...

I agree that motorcycle engine mechanics would have tools to do this....My son has been around motorcycles all his life......

I also think Terry's idea of cutting the bosses down is a very good one......Not real hard to do it either.....

04-09-2011, 05:02 PM	#10
Rich Biebel VIP Member Join Date: Jun 2007 Location: Northern New Jersey suburbs Posts: 2,314 Likes: 25 Liked 544 Times in 213 Posts	Re: Any machinists set valves on an DOHC motor? Get a pair(1 Int and 1 ex) set at the valve to whatever lash you want and then see what it is between the cam and the roller. A feeler gauge should work ......Once you know the number that is at the cam/roller with the proper lash at the valve tip..... set them all at the cam/roller contact area. They do make very thin open end wrenches once know as tappet wrenches that might work on the adjusters... I agree that motorcycle engine mechanics would have tools to do this....My son has been around motorcycles all his life...... I also think Terry's idea of cutting the bosses down is a very good one......Not real hard to do it either..... __________________ Rich Biebel S/C 1479 Stock 147R Last edited by Rich Biebel; 04-09-2011 at 05:06 PM.