Quote:
Originally Posted by Chris Williams
All good info. FWIW, you can set the 3/4 timers to 0.000 and they are just ignored.
|
Not the case ..... according to the dedenbear cc3 the 3 & 4 timers need to be set at a higher number than 1 & 2 so if you shift the car on time at 1.00 sec timers must be set as follows:
B1: 1.00 (this is the shift point)
B2: 1.50 (means the shift solenoid will stay engaged for .50sec)
B3: 3.00 (or any number higher than 1.50)
B4: 3.00 (must be same as A3 to cancel out second shift)
Connect one side of the shifter solenoid to ground and connect the other side of the wire to timer B on the CC3 box. You can also put a 2 accessory switch in between the RPM Switch, Delay box and shifter to switch from time to RPM shifts at the flick of the switch.