Trans Yoke Roller Tail
 

Does anyone have or know who makes a Trans yoke for a T350 for a roller tail, with a 6.5 in from center of joint (1350) to the yoke end? Only one I can find is a Moser that's a 6in center to end.

Re: Trans Yoke Roller Tail
 

I didn't go through the full list, but Sonnax has a selection of performance yokes.

https://www.sonnax.com/slip_yokes

Good luck!

Re: Trans Yoke Roller Tail
 

Every billet 1350 yoke I've used in the last several years is 6" long , roller or bushing .
With the yoke properly engaged into the trans there should be no need for a longer one .
If the driveshaft is too short and you need the extra 1/2" to get the yoke into the bearing ,you're setting yourself up for other possible issues .
Besides stressing the splines ,the yoke can bind on the spline when the yoke is too far out on the shaft.

Re: Trans Yoke Roller Tail
 

Did you try Mark Williams