are trw pistons any good
 

for a stocker motor or are they just for a standard rebuild?

Thanks

Dave

Re: are trw pistons any good
 

Probably too heavy.

Re: are trw pistons any good
 

David,

What kind of engine?

Re: are trw pistons any good
 

Thanks for the reply Jim, its going to be a 1975 350 chevy nova in I/SA. The long term goal is to hand it over to my nephew who is now 14 and I will return to racing my Duster. I want to keep him on the straight and narrow and the drag strip and the people there are the perfect examples for him

I think we met long ago in Houston. I was with Jeff Ferguson and Mike Maryonne.

Re: are trw pistons any good
 

TRW pistons work great for LEGAL stocker engines.

Re: are trw pistons any good
 

Dave,

I ran one of those motors for years and I will just say there are better choices. I used the TRW pistons for a while, and they used to be much nicer to the wallet but they have some issues.

Re: are trw pistons any good
 

Can you expain what the issues are. I am not planning on a killer motor, that will come later. In the beginning it will be a bracket car and got to 3 or four div a year if I am lucky.

Re: are trw pistons any good
 

Dave,

I sent you a PM.

Re: are trw pistons any good
 

Hey David,

Sorry it took me so long to get back on here. Like some of the other guys have already said, there are a lot better choices out there than the TRW stuff. The machine work in the ring land area is not that good and they are tough on the cylinder walls IMO.

Good Luck, and I do remember meeting you at Houston or Baton Rouge. Jim

Re: are trw pistons any good
 

There was a time when TRW pistons were affordable and there was little else to offer. Considering the cost of a new set today, those offered by CP, Ross, etc. are not only vastly superior in technology and quality, but the cost difference is negligible. Remember, ring seal and reducing friction is key to a fast engine. Both are difficult (but not impossible) with a inferior piston.
But if you have an old set laying around and just need to get it running on a tight budget, then go ahead. Have somebody prepare a high quality set of rings that are gapped, thinner with spacers and back-cut. Vertical clearance is important and can be adjusted with spacers. But you will not obtain the machining tolerance on the lands as offered by the other race piston manufacturers. Not out of the box anyways.