|
|
01-06-2021, 07:57 PM | #1 |
Member
Join Date: Dec 2014
Location: Perry, GA
Posts: 329
Likes: 11
Liked 236 Times in 89 Posts
|
another 200 question
What would make it basically pump the fluid out of the vent tube(this one is near bellhousing). It is fresh and Ultrabell is installed if that matters. Chrome pan also
|
01-06-2021, 08:41 PM | #2 |
Senior Member
Join Date: Mar 2002
Location: Warsaw, Mo
Posts: 643
Likes: 558
Liked 989 Times in 302 Posts
|
Re: another 200 question
Sounds like to much fluid, the after market locking dip sticks are not real accurate. Better to have to much then to little, run a tube from the over flow vent to a catch tank. Gary Stinnet sells a nice one.
Randy Wells I/S 5628 |
Liked |
01-07-2021, 10:16 AM | #3 |
Senior Member
Join Date: Feb 2002
Location: Southeast Michigan
Posts: 885
Likes: 63
Liked 221 Times in 102 Posts
|
Re: another 200 question
The venting system has passages that run through the pump . It is critical that the pump cover and pump body have flat surfaces with no burrs . The bolts need to be torqued to specs . Also some aftermarket trans recalibrations run too much line pressure , and that could cause cross channel leaks into the venting system . Probably best to relocate the vent to the back of the case , and plug the bellhousing vent . If that's not possible , add a hose on to the vent tube and run that down to a catch bottle .
|
01-07-2021, 11:57 AM | #4 |
Veteran Member
Join Date: Mar 2002
Location: Miles From Nowhere
Posts: 7,418
Likes: 2,582
Liked 4,453 Times in 1,694 Posts
|
Re: another 200 question
I gave up on attempting to baffle the vent hole through the pump .There's just too much fluid flying off the direct drum , at the the RPMs these things see, in race cars.
As Russ said , I move the vent to the rear. There's a flat area up top that had a vent on the very early models. You can tap a hole to 1/8th pipe and add a fitting and contain any fluid easier there. Pull the tube out of the case up front, and J-B weld it up.
__________________
We are lucky we don't get as much Government as we pay for..... Will Rogers |
Liked |
01-07-2021, 02:53 PM | #5 |
Member
Join Date: Dec 2014
Location: Perry, GA
Posts: 329
Likes: 11
Liked 236 Times in 89 Posts
|
Re: another 200 question
Mark, my question is why did this start. It did not do it before. Only change was eshift vb to Sepanek manual vb and added an ultrabell. Bell is not touching case but there are 3 tabs sticking out by pump that I had to touch with a grinder, maybe pump is not seating all the way?
|
01-09-2021, 09:28 PM | #6 |
Member
Join Date: Feb 2006
Location: Holland, MICHIGAN
Posts: 155
Likes: 39
Liked 26 Times in 8 Posts
|
Re: another 200 question
go to https://www.turboaction.com/ and read tech tip #12
|
Liked |
|
|