|
06-23-2019, 05:45 PM | #1 |
VIP Member
Join Date: Aug 2013
Posts: 1,766
Likes: 1,197
Liked 1,957 Times in 492 Posts
|
Racepak sensor thread?
Anyone know the thread diameter and pitch of a racepak driveshaft/clutch sensor? Is it just 5/16-24, standard fine thread?
__________________
Todd Greene |
06-23-2019, 07:27 PM | #2 |
Junior Member
Join Date: Jul 2018
Posts: 44
Likes: 342
Liked 38 Times in 14 Posts
|
Re: Racepak sensor thread?
It is just standard 5/16-24 fine thread.
The same sensor that is used in my Strange Ultra Case third member. |
Liked |
06-23-2019, 08:18 PM | #3 |
VIP Member
Join Date: Aug 2013
Posts: 1,766
Likes: 1,197
Liked 1,957 Times in 492 Posts
|
Re: Racepak sensor thread?
Thank you.
__________________
Todd Greene |
06-26-2019, 08:15 AM | #4 |
Junior Member
Join Date: Apr 2006
Posts: 96
Likes: 0
Liked 20 Times in 12 Posts
|
Re: Racepak sensor thread?
The 800-SS-ZX3 clutch sensor is 3/8-24 NF threads.
|
06-26-2019, 08:38 AM | #5 |
VIP Member
Join Date: Aug 2013
Posts: 1,766
Likes: 1,197
Liked 1,957 Times in 492 Posts
|
Re: Racepak sensor thread?
Thanks matt, I just wasn't sure if the thread pitch was something special and I didn't have any with me to check.
__________________
Todd Greene |
06-26-2019, 02:00 PM | #6 |
Member
Join Date: Dec 2009
Location: Hainesport, NJ
Posts: 123
Likes: 0
Liked 15 Times in 2 Posts
|
Re: Racepak sensor thread?
Matt is correct the Zx3 is 3/8-24. Occasionally a real old Jerico is setup for 5/16-18.
More and more guys are putting the sensor in the trans case: |
Liked |
07-16-2019, 08:17 PM | #7 |
Senior Member
Join Date: Feb 2008
Location: Georgetown, Indiana (close to Louisville, KY)
Posts: 760
Likes: 492
Liked 224 Times in 103 Posts
|
Re: Racepak sensor thread?
Would be nice to see a fitting that would fit speedo cable hole since its not used.
|
|
|