|
09-15-2020, 05:43 PM | #31 |
Member
Join Date: May 2010
Location: El Dorado Ca.
Posts: 116
Likes: 240
Liked 34 Times in 20 Posts
|
Re: Broken Front Wheel Studs
I bought some Moser studs for my rear axels, and i was not impressed with the quality.
__________________
Steven Barnes Stock 704 N/SA |
10-10-2020, 08:35 PM | #32 |
Member
Join Date: Apr 2004
Posts: 171
Likes: 0
Liked 29 Times in 15 Posts
|
Re: Broken Front Wheel Studs
The center bore on the wheel is something that was a problem when going to aftermarket brakes. Depending on the wheel brand, either the wheel had to be machined to accept the hub, or you had to run a spacer under the rotor hat. Even though the wheel would appear to sit flush on the hub, it would be off and start to bend the stud if you forced it to tighten up. This was something more specific to the 4 lug wheels compared to any of the 5 lug. So then even at a torque spec of 50lbs, it wouldnt torque correctly but it would tighten up. Would cause a pretty good vibration in the front end rolling along that you could chase for a bit.
|
11-21-2020, 10:36 PM | #33 |
Senior Member
Join Date: Sep 2007
Posts: 574
Likes: 6
Liked 44 Times in 22 Posts
|
Re: Broken Front Wheel Studs
Proper torque is affected strongly by cleanliness of threads, coating on the threads, type of lube,
|
Thread Tools | |
Display Modes | |
|
|