|
05-04-2022, 08:17 PM | #1 |
Member
Join Date: Dec 2009
Location: Kingman, NW AZ. in the middle of the longest stretch of Route 66
Posts: 306
Likes: 0
Liked 17 Times in 13 Posts
|
SBC Cam Bearing?
putting together a '66 327 stocker engine. most guys put the oil hole in #s2,3 & 4 straight down, 6:00. I always put the oil hole at 3:30. believing that the journal could get a bit more oil before the Big load, at 6:00.
thoughts? thanks Rod in AZ |
05-05-2022, 06:52 AM | #2 |
VIP Member
Join Date: Nov 2002
Location: Massapequa Park,NY
Posts: 1,206
Likes: 1,727
Liked 822 Times in 264 Posts
|
Re: SBC Cam Bearing?
2 o clock
__________________
1989 Camaro Iroc-Z I/SA B&B Auto Machine Shop. |
Liked |
05-05-2022, 07:03 AM | #3 |
Member
Join Date: Nov 2005
Location: Waldorf Md
Posts: 222
Likes: 10
Liked 26 Times in 15 Posts
|
Re: SBC Cam Bearing?
Here is a diagram from the Durabond web site
__________________
Bill Koustenis |
05-08-2022, 12:15 PM | #4 |
Member
Join Date: Dec 2009
Location: Kingman, NW AZ. in the middle of the longest stretch of Route 66
Posts: 306
Likes: 0
Liked 17 Times in 13 Posts
|
Re: SBC Cam Bearing?
thanks for the replies. especially the pie chart. this small town kid wasnt far off.
Rod in AZ |
05-09-2022, 08:05 AM | #5 |
VIP Member
Join Date: Nov 2002
Location: Massapequa Park,NY
Posts: 1,206
Likes: 1,727
Liked 822 Times in 264 Posts
|
Re: SBC Cam Bearing?
Put #1-5 all in at 2 oclock
__________________
1989 Camaro Iroc-Z I/SA B&B Auto Machine Shop. |
|
|