ET with and without wheelie.

[KennyAnderson]

Originally Posted by Ed Carpenter

With my Chevy II if we tied it down it would lose .10 loosing it back up to do huge wheelstands it would pick that .10 right back up. Just my experience.

This is preposterous!!!! Didn't you read what 1320 said!?!?!?

[1320racer]

As usual you add nothing of relevance to a thread, you’re a clown!

Now what is preposterous is some here believe that a car can break the 60 foot beams just as quick with the back tires as it can with the front tires!

[Frank Castros]

Originally Posted by 1320racer

Frank, it depends on any given race day/weekend as to what I want it to be as we adjust the front shocks based on DA and continue to do so throughout the day and night as the DA rises and falls so the wheelie and 60 foots remain consistent. This past weekend they were low 1.26 over 3 days. That said, the best ever has been 1.17

Obviously 1.26 and 1.17 is a huge difference within sixty feet. Why and what track was the 1.17?

[1320racer]

No wheelie and Atco

[nickh]

Back in 2005 we ran TS with Jerry Haas built car. We experimented with wheelie bar settings. We found that the car liked 5" height for wheelie bars, our car was pretty consistent tripping 60' clocks at 1.02 with back tires. We went to 4" on bars the car slowed to 1.04, we went to 6" on bars and car hit the bars too hard and unloaded chassis. We went back to 5" and the car went right back to 1.02 tripping with back tires.

Every car is different, you have to find that sweet spot in every car no matter how fast or slow.

Ed you guys have found the sweet spot with the Firebird. Car leaves flawless every pass, your chevelle was awesome to watch and was consistent. But you had to spend the time with it to find what it wanted, shocks & settings, travel limiters or non, rear suspension settings, etc..

Make 1 small change, keep good notes or read your data acquisition.

[Frank Castros]

I have often wondered about this subject and I always think about Morehead's Camaro because IMHO is the best leaving Super Stock in the sport and is Holt built.

However;

I remember being at the Summernationals at Englishtown when Alderman was driving the Wayne County Daytona and they were bad fast at the time (and that's another story) the car barely lifted the wheels but carried them for over 100' and qualified on the pole. That was one of the most impressive thing I ever seen a race car do.
Now you can say that they were cheaters and you would be right but at the same time those boys knew their stuff.

[Frank Castros]

Doug Battipaglia of Flo Designs who did the heads on the Wayne County car told us they never tested with other Pro Stock teams present. It was all Top Secret as per Chrysler Corp.
Doug didn't do our heads, Bill Ceralli did but Doug provided some speed secrets.

[Frank Castros]

Oh by the way Bill Ceralli is the most talented and skilled machinist ever.

[Adger Smith]

Frank, I have a set of the B-1TS-8 heads done by Doug.. Good heads.
What happened to him.. Lost track of him several years ago