|
![]() |
#1 |
Junior Member
Join Date: May 2015
Posts: 8
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
I freshened my SBC over the winter and now I am have a problem with my ignition system.I use a MSD crank trigger with a 6AL box and a crank trigger distributor.Before the rebuild I could only run about 34 degrees of timing, because it was hard to start.Now it fires up now matter how much timing.I have set it from 32 to 49 degrees and starts up with no problem.I changed the pickup,cable to the box,new coil, and tried 2 different ignition boxes and nothing changes.The car is also about a half second slower, but still consistent.Anyone have any idea what else to try? Thanks
|
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Mar 2002
Posts: 1,069
Likes: 42
Liked 414 Times in 92 Posts
|
![]()
Distributor phased properly?
__________________
68 Chevy11 327 F/S |
![]() |
![]() |
![]() |
#3 |
VIP Member
Join Date: May 2006
Location: Murfreesboro TN
Posts: 4,951
Likes: 1,044
Liked 1,126 Times in 297 Posts
|
![]()
Are you absolutely certain that nothing is wrong with your harmonic balancer, and your timing pointer? Are you sure that what you have for TDC there is actually true TDC for the engine? Have you checked that since the engine was first started?
__________________
Alan Roehrich 212A G/S |
![]() |
![]() |
![]() |
#4 |
Junior Member
Join Date: May 2015
Posts: 8
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
I found the distributor phasing was off, so I adjusted it.Still starts very easy @ 40 degrees.I also set #1 at TDC and the balancer was at TDC. May pull out this system and try an old electronic distributor just to see what happens.
|
![]() |
![]() |
![]() |
#5 |
VIP Member
Join Date: Mar 2007
Posts: 2,333
Likes: 549
Liked 1,658 Times in 508 Posts
|
![]()
Have you put leak down check on the engine or a compression test. Sounds like you could have a ring seal issue after the freshen up. Low compression would allow the engine to crank over easier. I had a similar issue after a freshen up and the compression was so low the engine would not start after one pass.
__________________
Mike Pearson 2485 SS |
![]() |
![]() |
![]() |
#6 |
Junior Member
Join Date: May 2015
Posts: 8
Likes: 0
Liked 0 Times in 0 Posts
|
![]()
Compression ranges from 170 -180,have not done a leak down test. Borrowing an HEI distributor and going to try that.
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Jan 2007
Location: N/A
Posts: 882
Likes: 0
Liked 20 Times in 20 Posts
|
![]()
Try a new pickup unless you already have.
__________________
don,t have one |
![]() |
![]() |
![]() |
|
|