|
01-28-2013, 06:54 AM | #11 |
VIP Member
Join Date: Dec 2008
Location: Richmond Hill GA (and Port Ludlow WA)
Posts: 4,213
Likes: 2,156
Liked 2,944 Times in 905 Posts
|
Re: Need help with rules
Jon, good call; you can use a swing out bar if that helps...
Jim, bolted in is permissible; this is copied straight from the rulebook general reg section so of course the wheel tub comment doesn't apply to a Stocker: "All vehicles with OEM frame must have roll bar welded or bolted to frame; installation of frame connectors on unibody cars does not constitute a frame; therefore it is not necessary to have the roll bar attached to the frame. Unibody cars with stock floor and firewall (wheeltubs permitted) may attach roll bar with 6-inch x 6-inch x .125-inch steel plates on top and bottom of floor bolted together with at least four 3/8-inch bolts and nuts, or weld main hoop to rocker sill area with .125-inch reinforcing plates, with plates welded completely"
__________________
Jim Carter 2340 Super Stock 2340 SST/2340 Stock Set another place at the table |
01-28-2013, 07:43 PM | #12 |
Junior Member
Join Date: Jan 2013
Posts: 4
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Need help with rules
Yes you can have it bolted in it is in the nhar rulebook is was looking into it myself
|
|
|