|
![]() |
#1 |
Member
Join Date: Sep 2006
Location: Kilgore TX
Posts: 435
Likes: 5
Liked 78 Times in 39 Posts
|
![]()
Someone on some forum [I don't remember who or where] talked about using the OE rear swing arms and adapting them to a solid axle with a custom-built adapter. The way I remember the story, he built an adapter with the OD of the inside of the trailing arm, and the ID of the new rear housing tube. But I do not remember what else he did to control the rear axle. Was that someone on this forum? I think it was someone with a stocker.
|
![]() |
![]() |
![]() |
#3 | |
Senior Member
Join Date: Feb 2008
Location: Georgetown, Indiana (close to Louisville, KY)
Posts: 762
Likes: 494
Liked 225 Times in 104 Posts
|
![]() Quote:
|
|
![]() |
![]() |
Liked |
![]() |
#4 |
Member
Join Date: Feb 2011
Location: Ottawa,Ont.,CANADA
Posts: 129
Likes: 107
Liked 69 Times in 16 Posts
|
![]()
My C2 was done by Billy Nees over 20 years ago,using modified trailing arms to a 12 bolt..
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|