Rear axle question

L.Fite · 10-15-2021, 10:25 PM

A couple of (or three) thoughts...

1) I would think they should engage the full length of the splined area in the spool... How much spline is in the spool?

2) The other thing that occurs to me is the minimum would be at least the diameter of the axle...

3) If in doubt, call the manufacturer of the spool and axles.

GTX JOHN · 10-16-2021, 12:00 AM

The rule of thumb on fasteners is Thread engagement
should be the diameter of bolt.

However, I do not advise less than double that with
a spool. Unless of course, you like to knock down the
Tree like I did some years ago at Winternationals.

10-15-2021, 10:25 PM	#1
L.Fite Senior Member Join Date: May 2020 Posts: 516 Likes: 548 Liked 496 Times in 243 Posts	Re: Rear axle question A couple of (or three) thoughts... 1) I would think they should engage the full length of the splined area in the spool... How much spline is in the spool? 2) The other thing that occurs to me is the minimum would be at least the diameter of the axle... 3) If in doubt, call the manufacturer of the spool and axles.

10-16-2021, 12:00 AM	#2
GTX JOHN VIP Member Join Date: Jun 2009 Location: Boulder City, Nevada 89005 Posts: 2,733 Likes: 2,799 Liked 2,483 Times in 697 Posts	Re: Rear axle question The rule of thumb on fasteners is Thread engagement should be the diameter of bolt. However, I do not advise less than double that with a spool. Unless of course, you like to knock down the Tree like I did some years ago at Winternationals. __________________ John Irving 741 Stock 741 Super Stock

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode