|
|
|
|
07-24-2018, 11:17 PM
|
#1 |
|
Junior Member
Join Date: Nov 2010
Posts: 41
Likes: 4
Liked 11 Times in 5 Posts
|
Re: trend lifters
Had to use the .014 cups in my flat tappet trends also, Cleveland with non restricted pushrods.
Cheers Paul |
|
|
|
07-25-2018, 03:29 PM
|
#2 |
|
Guest
Posts: n/a
|
Re: trend lifters
For a Pontiac I would just tap the block for lifter bore restrictors. 1/4 20 tap fits in the existing holes that feed the lifters inside the lifter bores. Then use brass set screws and go with a .016 to .018 drill to make the holes. That should slow the oil down
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
