8.5 S Spring Posi

Randy Schonscheck · 06-22-2018, 12:31 AM

Thanks Alan, My clips are in the .147 to .150 range. I'm going to see if I can hunt up some thinner ones or have some machined to thinner specs. I've run into silly problems in the past but this one takes the cake.

Alan Nyhus · 06-22-2018, 07:33 AM

You can also machine a flat on the cross shaft. -Al

Tom Broome · 06-22-2018, 01:37 PM

Street car I hope. I'm with the others, clearance the cross shaft (do they still make the notched ones) or thinner clips.

06-22-2018, 12:31 AM	#1
Randy Schonscheck Junior Member Join Date: Feb 2002 Location: Omro, WI Posts: 64 Likes: 0 Liked 2 Times in 2 Posts	Re: 8.5 S Spring Posi Thanks Alan, My clips are in the .147 to .150 range. I'm going to see if I can hunt up some thinner ones or have some machined to thinner specs. I've run into silly problems in the past but this one takes the cake.

06-22-2018, 07:33 AM	#2
Alan Nyhus VIP Member Join Date: Dec 2002 Location: Lower Dakota territory Posts: 1,180 Likes: 1,074 Liked 799 Times in 236 Posts	Re: 8.5 S Spring Posi You can also machine a flat on the cross shaft. -Al __________________ "That'll never work....."

06-22-2018, 01:37 PM	#3
Tom Broome Member Join Date: Sep 2009 Posts: 144 Likes: 80 Liked 88 Times in 43 Posts	Re: 8.5 S Spring Posi Street car I hope. I'm with the others, clearance the cross shaft (do they still make the notched ones) or thinner clips.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode