WTB Input Shaft for Jerico DR4

[james schaechter]

Originally Posted by Don Fardie

Wasn't aware there were different lengths? I know there is a shorter version of the Jerico, but not the inputs. If that is the case it would be the input for the standard length Jerico.

Jerico inputs typically come in a length for a stand depth bell or a deeper bell that is one inch longer. May be they have custome lenths but I have not seen that.

The thing to watch is the type and version of the input. The early narrow gear DR4 is different than the small bearing wide gear DR4 vs the Big bearing wide gear DR4 vs the
DR4-4. Not to mention other versions that are not DR. Models. Of course, the pilot tip can be different as well.

The length of the trans won’t matter unless you are talking output shafts.

You might check to see what the case number is on your trans and call Scott at Jerico. They are not too expensive compared to used and you will get a new one. If you have an older model and can’t get one new, you need to do some research to be sure it is compatible. Hope this helps. Jim