Carb Help

Dave Goob Cook · 12-31-2007, 04:14 AM

I usually see 92's squared on those, be sure to balance the front/rear idle speed screws and run it about 1/8th to 1/4 turn fat on the idle mix screws. .035-.037 shooters are usually ballpark.
The usual stuff, jet extensions, notched float, brass or Nitrophyl float in front, not a white plastic.

Watch out for a drippy metering block(s) if it's a fairly old unit.

CPOlesen · 01-02-2008, 12:39 PM

thanks dave i'll check it out

12-31-2007, 04:14 AM	#1
Dave Goob Cook Member Join Date: Dec 2006 Location: Indy Posts: 422 Likes: 0 Liked 0 Times in 0 Posts	Re: Carb Help I usually see 92's squared on those, be sure to balance the front/rear idle speed screws and run it about 1/8th to 1/4 turn fat on the idle mix screws. .035-.037 shooters are usually ballpark. The usual stuff, jet extensions, notched float, brass or Nitrophyl float in front, not a white plastic. Watch out for a drippy metering block(s) if it's a fairly old unit.

01-02-2008, 12:39 PM	#2
CPOlesen Junior Member Join Date: Dec 2007 Location: Chandler, Oklahoma Posts: 23 Likes: 0 Liked 0 Times in 0 Posts	Re: Carb Help thanks dave i'll check it out

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode