Update E-F/SA Bird Build... - Page 30

black88coupe · 03-25-2015, 07:47 AM

nice!

brent flynn · 03-26-2015, 07:51 PM

Quote:

Originally Posted by HandOverFist

Going to be sunny and 49 degrees at Bowling Green this Saturday. Not sure I want to even try here.

We were supposed to open this weekend too, but no way.. IM shooting for next Wednesday...if that dont work, Next Saturday it is... Engine all done, and ready...just need to put hood on, recheck trans fluid, check rear wheel torque, and hopefully clean it up a bit... ready for testing...

brent flynn · 03-26-2015, 07:54 PM

Quote:

Originally Posted by black88coupe

nice!

Thanks Mitch!

brent flynn · 03-26-2015, 10:09 PM

New cam and limited travel lifters(CHris Hardy @ RET Racing Engines Techologies) all snuggled in their new home... Testing April 1st, if weather agrees... New 350 Trans, heater removed, built new carb( wont test until 2nd or 3rd outing)... 11.44/116/1.506 previous best, lookin for 11.20/118/1.47

HandOverFist · 03-26-2015, 10:19 PM

I know you are chompin at the bit to go Brent. It will be a miracle to get the Mustang ready by April 12th, first combo event at BG. I hope that 'Bird flies for you!

brent flynn · 03-27-2015, 08:21 PM

Rich, you gonna try to make Indy, May1? Im planning on it, unless the weather looks too sketchy, then i will focus on Norwalk Divisional , later in the month...
Hope the "stang is comin together!

brent flynn · 04-10-2015, 10:10 PM

Well, testing at Indy this Sunday! Muncie closed, due to too much water in the pits( massive rains this week)... Hope to get some good clean passes with the new cam/lifters/trans... Hopefully they will have scales operating...

brent flynn · 04-16-2015, 09:41 PM

Well. just getting around to posting my results from last weekend's testing... Wasnt what i was hoping for, but i think i can find some ET... Big cam didnt do what i thought it would do, but i may be off of carb tune(maybe on the rich side), and will fiddle with timing again on the next test day... car went, in order, 11.50/11.51/11.50 changed carbs 4th pass, stuttered 11.64/115, and put original carb back on for 5th pass : 11.49
Below is a link to some video.... 3 passes out of 5... last past , after 4 min mark, was the 11.49 pass, left the best. I did mess with metering on 2nd run, but it didnt like more fuel, so i put it back, mainly to see if car would launch better...i think it may've needed less fuel.

HandOverFist · 04-16-2015, 11:54 PM

It will come around Brent. I got the trans back in the Camaro today...will see what direction I took over the winter hehe.

brent flynn · 04-17-2015, 06:36 AM

anxious to hear about your test runs...goin out this weekend?

03-25-2015, 07:47 AM	#291
black88coupe Member Join Date: Jan 2008 Posts: 352 Likes: 18 Liked 19 Times in 12 Posts	Re: Update E-F/SA Bird Build... nice! __________________ Mitch Beri- The Motor City 1985 GT- “Stock-ish” 5.0 motor, AOD/ trans brake. 12.68 @ 101.31mph. https://www.facebook.com/groups/FOXBODYFLEAMARKET/

03-26-2015, 10:09 PM	#294
brent flynn Senior Member Join Date: Apr 2011 Location: Middletown, IN Posts: 593 Likes: 0 Liked 0 Times in 0 Posts	Re: Update E-F/SA Bird Build... New cam and limited travel lifters(CHris Hardy @ RET Racing Engines Techologies) all snuggled in their new home... Testing April 1st, if weather agrees... New 350 Trans, heater removed, built new carb( wont test until 2nd or 3rd outing)... 11.44/116/1.506 previous best, lookin for 11.20/118/1.47 __________________ 1968 Bird/TRW 455/Home ported 13's, '70 Qjet,Holley Street Dominator manifold, Comp Solid FT, 10.817/122.30/1.440 Workin' on E/SA combo 3119 E/SA

03-26-2015, 10:19 PM	#295
HandOverFist VIP Member Join Date: Oct 2013 Location: Gulf Breeze, FL Posts: 1,651 Likes: 8 Liked 33 Times in 16 Posts	Re: Update E-F/SA Bird Build... I know you are chompin at the bit to go Brent. It will be a miracle to get the Mustang ready by April 12th, first combo event at BG. I hope that 'Bird flies for you! __________________ Rich Taylor I/SA - 321

03-27-2015, 08:21 PM	#296
brent flynn Senior Member Join Date: Apr 2011 Location: Middletown, IN Posts: 593 Likes: 0 Liked 0 Times in 0 Posts	Re: Update E-F/SA Bird Build... Rich, you gonna try to make Indy, May1? Im planning on it, unless the weather looks too sketchy, then i will focus on Norwalk Divisional , later in the month... Hope the "stang is comin together! __________________ 1968 Bird/TRW 455/Home ported 13's, '70 Qjet,Holley Street Dominator manifold, Comp Solid FT, 10.817/122.30/1.440 Workin' on E/SA combo 3119 E/SA

04-10-2015, 10:10 PM	#297
brent flynn Senior Member Join Date: Apr 2011 Location: Middletown, IN Posts: 593 Likes: 0 Liked 0 Times in 0 Posts	Re: Update E-F/SA Bird Build... Well, testing at Indy this Sunday! Muncie closed, due to too much water in the pits( massive rains this week)... Hope to get some good clean passes with the new cam/lifters/trans... Hopefully they will have scales operating... __________________ 1968 Bird/TRW 455/Home ported 13's, '70 Qjet,Holley Street Dominator manifold, Comp Solid FT, 10.817/122.30/1.440 Workin' on E/SA combo 3119 E/SA

04-16-2015, 09:41 PM	#298
brent flynn Senior Member Join Date: Apr 2011 Location: Middletown, IN Posts: 593 Likes: 0 Liked 0 Times in 0 Posts	Re: Update E-F/SA Bird Build... Well. just getting around to posting my results from last weekend's testing... Wasnt what i was hoping for, but i think i can find some ET... Big cam didnt do what i thought it would do, but i may be off of carb tune(maybe on the rich side), and will fiddle with timing again on the next test day... car went, in order, 11.50/11.51/11.50 changed carbs 4th pass, stuttered 11.64/115, and put original carb back on for 5th pass : 11.49 Below is a link to some video.... 3 passes out of 5... last past , after 4 min mark, was the 11.49 pass, left the best. I did mess with metering on 2nd run, but it didnt like more fuel, so i put it back, mainly to see if car would launch better...i think it may've needed less fuel. __________________ 1968 Bird/TRW 455/Home ported 13's, '70 Qjet,Holley Street Dominator manifold, Comp Solid FT, 10.817/122.30/1.440 Workin' on E/SA combo 3119 E/SA

04-16-2015, 11:54 PM	#299
HandOverFist VIP Member Join Date: Oct 2013 Location: Gulf Breeze, FL Posts: 1,651 Likes: 8 Liked 33 Times in 16 Posts	Re: Update E-F/SA Bird Build... It will come around Brent. I got the trans back in the Camaro today...will see what direction I took over the winter hehe. __________________ Rich Taylor I/SA - 321

04-17-2015, 06:36 AM	#300
brent flynn Senior Member Join Date: Apr 2011 Location: Middletown, IN Posts: 593 Likes: 0 Liked 0 Times in 0 Posts	Re: Update E-F/SA Bird Build... anxious to hear about your test runs...goin out this weekend? __________________ 1968 Bird/TRW 455/Home ported 13's, '70 Qjet,Holley Street Dominator manifold, Comp Solid FT, 10.817/122.30/1.440 Workin' on E/SA combo 3119 E/SA

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode